Capabilities

Project Management

Project planning, scheduling and cost control

Process / Chemical Engineering

Process design, modeling and simulation, PFD and H&MB development, equipment and instrument process requirements

Facilities / Mechanical Engineering

Mechanical equipment and system design & specification, P&ID development, piping system design

Civil / Structural Engineering

Site development, shallow & deep foundation design, structural analysis, steel & concrete design

Electrical Engineering

High and medium voltage electrical power generation, distribution and switchgear design & evaluation

Instrument & Controls Engineering

Pneumatic and hydraulic controls system design, instrument specifications, SIL Evaluation

Programming

Process controls architecture and programming, PLC programming, DCS and HMI configuration

HSE, Regulatory and Safety

Local, state and federal permitting, MMS and USCG regulations, process safety management (PSM), process hazard analysis (PHA)

Procurement

Quotation and bidding, requisitions, and expediting

• Air Pollution Reduction

• Chemical Treatment

• Vapor Recovery

• Waste Heat Recovery and Cogeneration

• Waste Water Treating and Disposal

• Metallurgy

• Bulk Fluids Storage, Transfer and Handling

• Drains and Sumps

• Flare, Vent and Relief Systems

• Fired Heaters and Boilers

• Gas Compression and Storage

• Gas Dehydration and Metering

• Heat Exchangers

• Life and Fire Production Systems

• Oil and Gas Separation

• Oil Treating, Storage and Metering

• Pig Launching and Receiving

• Solids and Waste Storage, Transfer and Handling

• Piping and Vessels

• Production Manifolds

• Rotating Equipment

• Waterflood

• Platforms, Bridges, and Booms

• Caissons, Boat Bumpers, Well Protectors

• Finite Element Analysis (FEA)

• Fixed Platforms (Jacket, Deck and Piles)

• Modular and Skidded Structures

• Piers and Docks

• Quarters Buildings and Heliports

• Concrete Structures

• Shallow and Deep Foundations

• Wind Loading Analysis

• Structural Assessments (Section 17)

• Above and Below Grade Cable Raceway

• Above and Below Grade Grounding

• Electrical / Control Room Layout

• Emergency / Stand-by Power

• High Voltage Switchyard Design

• Lighting Systems

• Motor Control Design

• Power System Design

• Switchgear Control Design

• Communications and Security

• Fire and Gas Detection Systems

• Instrumentation and Control Systems

• PLC Programming and HMI Interface

• Panel and Marshalling Rack Design

• SIL Evaulation